25/02/13How to install CameraLink grabber driver
Installation steps:
1) The camera is connected through two CameraLink lines to the installed CameraLink grabber CameraLink1 and CameraLink2 interfaces on the computer and the host, and the interface order needs to be one to one (Aries 16 camera only needs to be connected to one CameraLink line).
2) Open the supporting U disk, find the collection card driver installation package.
3) Double-click to run the CameraLink grabber driver, click [Next] to install by default, and finally click [Finish], restart the computer host, and complete the installation.
4) After the drive installation is completed, please restart the computer.
CameraLink driver installation is complete, then open the device manager of the computer. When the driver installation is successful, the CameraLink grabber will appear displaying the FireBird Baseboard under Device Manager. Connecting the camera will occupy the COM port, as shown in the figure below.
